ISO. Second edition. Reference number Permission can be requested from either ISO at the address below or ISO’s member body in the. 31 Jul Purchase your copy of BS EN ISO as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards. EN ISO Intravascular catheters – Sterile and single-use catheters – Part 5 : Over-needle peripheral catheters – ISO specifies requirements.
|Published (Last):||2 January 2005|
|PDF File Size:||9.81 Mb|
|ePub File Size:||1.84 Mb|
|Price:||Free* [*Free Regsitration Required]|
When tested in accordance with annex E, fluid shall not leak out of the vent fitting within 15 s. I Principle Water is allowed to flow through the catheter and the amount of flow is measured either volumetrically 100555-5 gravimetrically. The number of significant iso 10555-5 retained in iso 10555-5 rounded off value should be the same as that of the specified value in this standard.
The corresponding Indian Standards which are to be substituted in their places are listed below along with 10555- iso 10555-5 of equivalence for the editions indicated: Page 3, subclause 4. All standards are subject to revision, and parties to agreements based on this part of ISO are encouraged to investigate the possibility of applying the lso recent editions of the standards indicated below.
Iso 10555-5 the iso 10555-5 average water fiowrate to the nearest whole number of millilitres. Until that time, a manufacturer may label his product “radio- opaque” provided he can support this claim by demonstrat- ing that he has an appropriate method for showing radio- opacity.
Measure the time taken for fluid to form the first falling drop at the back of the vent fitting. This does not iso 10555-5 the free use, in the course of implementing the standard, of necessary details, such isi symbols and sizes, type or grade designations.
Fixed or removable fitting per- mitting venting of air while restricting or preferably preventing the escape of blood. This Indian Standard has been developed from Doc No.: Details of which is given in National Annex A. I Principle A force is applied successively tensile and connpress- iso 10555-5 to the needle tube and needle hub and the tube- hub union is then examined iso 10555-5 loosening.
Intravascular catheters ISO , -3, -4, -5
Add the following reference: Iso 10555-5 collection of colours. Certain conventions are, however, not identical to those used in Indian Standards. Peripheral intravascular catheter designed for the introduction of withdrawal of liquids or devices into iso 10555-5 from the peripheral vascular system.
No part of the these publications may be reproduced in any form without the prior permission in writing of BIS.
Assembly comprising at least a needle tube attached to, and communicating with, a needle hub. Annex D shows examples iso 10555-5 typical needle point geom- etries. Other parts of this iso 10555-5 are as follows: Suggested colour references for opaque naaterials are given in annex C.
Assembly comprising the cath- eter tube, catheter hub and any integral fittings.
BS EN ISO 10555-5:2013
iso 10555-5 The catheter tube may have a single lumen or multiple lumens. For the purpose of deciding whether a particular requirement of this iso 10555-5 is complied with, the final value, observed or calculated expressing the result of a test or analysis, shall be rounded off in accordance with Uso 2: Available from Munsell Color, N.
Attention is io drawn to the following: Blood flow into the needle iso 10555-5. Rigid tube with one end sharpened to facilitate entry into body tissue.
At iso 10555-5 time of publication, the editions indicated were valid. The assembly comprising at least a needle tube attached to and communicating with a needle hub. If a steel tube is used, it shall connply with ISO Bureau of Indian Standards BIS is a statutory institution established under the Bureau of Indian Standards Act, to promote harmonious development of the activities of standardization, iso 10555-5 and quality certification of goods and attending to connected matters in the country.
NOTE 3 The point should iso 10555-5 designed to be noncoring. Pages 1 and 2 4. Review of Indian Standards Amendments are issued to standards as the need arises on iso 10555-5 basis of comments. Iso 10555-5 BIS has the copyright isk all its publications. Catheter designed for the introduction or withdrawal of liquids or devices into or from the peripheral vascular system.
Part 1 General requirements do The technical committee has reviewed the provisions of the following International Standard iso 10555-5 in this adopted iso 10555-5 and has decided that it is acceptable for use in conjunction with this standard: Figure 1 — Typical over-needle peripheral intravascular catheter NOTE 2 At the time of publication of this part of ISOiso 10555-5 is no acceptable, validated test method to determine radio-detectability. Search the history of over billion web pages on the Internet.
An example of a suitable apparatus is shown in fig- ure B.